Create a Bootable Windows in Flash Disk | Tutorial

Posted on 8:09 PM by Unknown

When your computer is infected with the virus or your data is lost, it is so annoying. When you will fix you have to have that and this. Sometimes we are lazy because we have no such preparation. So every time your computer is experiencing this, you are confused. And finally choose to pay people to do these simple things.

So this time I'll share a little about the ways in which we will not be confused anymore. Way I meant is to make Bootable Windows in Flash Disk. Please learn step by step

Prepare Flash Disk (> 1GB), the operating system CD that will be used, BartPe (PE Builder), PE to USB, another computer using the same operating system and there cd room.
After all is ready, make a second preparation. Do the following process to be completed by another computer.
Prepare the software that you use. Try to open the folder its PE Builder, go to the plugins folder. You can see there is a lot of folders, the folders that will accommodate your software. Try to install the program into folders according to its name. I've never tried to install the programs that do not fit with the existing folder. Maybe if you want to try can be, as long as create new folders, not existing ones.
Well, your preparation, I think is already done. Now you already have all the supplies. I suggest you do install the anti-virus software and Norton Ghost, because it may be the most useful. Other software such as nero etc. may also be useful for certain occasions.
Then, run the PE Builder to make the installation of windows. If you do not know how, read this article. Perform the steps in which only the step "Process Image Windows", and stop there.
Above steps will produce an image, which later will we use. in it have the software that we have prepared earlier and also the operating system you use.
If the article I suggested above, the next step is to move the image into the cd, now we move into the flashdisc. How?
Now run the file PEtoUSB. Software is useful to move the image file into the flash was.
Make sure the flash is already plugged into the USB. If there is only one flash is plugged in the USB port it will automatically flash will appear in the list of PE to a USB device. Previously, save the data in the flash because we will do the flash format.
Make adjustments to the format option, according to the image above. For drive the label, the contents of your liking.
In Source Path, fill with the image source that we created earlier in ...\pebuilder3110a\BartPE. Check, "Enable File Copy", then select "Overwrite"
Click start, and wait until the process is complete, then close the program petousb.
Ok, everything was done. Now you go back to your own computer. start the computer and go into the BIOS. Set the initial boot into the first USB. And then plugged your flash. Restart your computer and wait until the boot is complete. Operating system is ready for use.